Projecta IM2000 Instructions d'exploitation télécharger pdf (Page 72)

70

Fi

g

ure D.2-A: Clips bein

g

installed on an IM483I

Figure D.2-C: Back view showing clips installed

on an IM483I

Figure D.2-B: Clip being inserted onto a case

Mountin

g

Plate

#10 Hardware

U3-CLP

Unit Case. Components

rem oved for sim plification.

Figure D.2: Attaching the U3-CLP to the IM483

Figure D.3: Mounting to a Panel

Mounting

The unit should be mounted in

accordance with Figure D.3 using the

recommended hardware. Ensure

that mounting hardware doesn’t

interfere with any circuitry or wiring.

NOTE: The

Mounting Clips

MUST be placed on

the side for which

they are designed. They are

not interchangeable. They

can, however, be attached

to either vertical plate of the

aluminum channel case.

WARNING! The

maximum plate

temperature for all

the units that may

be used with these clips is

70°C. It may be necessary to

install a fan in your enclosure

or provide additional heat

sinking to remain below this

temperature!

4 - # 10 Flat Washers

2 - 10 X 32 Nuts

Installation

Using the photographs in Figure

D.2, place the clips on the unit to

be mounted as shown. The clips

must be oriented in a fashion that

places the smaller retaining tab

between the bottom of the printed

circuit board and the aluminum

channel case (Figure D.2-B).

1 2 ... 67 68 69 70 71 72 73 74 75 76 77

Commentaires sur ces manuels

Pas de commentaire